Planning precedent report

The development consists of refurbishment works which consist of: 1. General refurbishment works. 2. New rooflight in rear slope of pitched roof and associated internal works. 3. Works to improve energy efficiency, which comprise: insulation of roof space (cold roof) with additional roof vents provided; replacement of existing lower ground floor with new insulated solid floor build up to include radon barrier; renewal of lower ground floor wall finishes; replacement of existing float glass with slim vacuum type energy efficient double glazing; localised insulation around window openings; installation of renewable energy services - air source heat pump and roof mounted PV/Solar panels (on rear, south-facing pitch). 4. Installation of a cavity type waterproofing system at lower ground floor level to address the high water table with vapour permeable lime based plaster finish to walls. 5. Alteration of 1No existing window opening on rear facade to form external door opening. 6. Alteration of 1970s/80s sub-divided lower ground floor room to provide family bathroom and corridor to side garage/storage. 7. General internal refurbishment and decoration works including relocation of kitchen from lower ground floor to upper ground floor. 8. Repairs and refurbishment to window and external door joinery, including replacement of modern external doors. 9. Installation of new electrical, heating and plumbing services. 10. Repairs and re-rendering chimney stacks and chimney pots. 11. Provision of EV charging point at front garden.

Permission for development. The development consists of the provision of an

Permission for developemnt consisting of the (a)

Permission is sought for the demolition of existing

Permission is sought for demolition of timber sun room

Retention permission is sought for alterations to the centre metal roof valley between the two apex roof sections. The works included replacement of all non-original defective copper metal and supporting plywood base to roof valley with new valley comprised of pressed copper metal laid to falls, dressed up the roof pitch sections eitherside and all installed on new marine grade plywood, existing slates to the affected area were stripped and re-installed. Existing valley drainage outlet penetrating the gable wall into the gutter was retained and dressed with new copper.